Home Page | Contact Us | About Us | Your Account | Basket Contents | Terms & Conditions | CHECKOUT | FREE SHIPPING On orders over $400.00
'06-'11 VRSCD Night Rod 8-9030-H4-X Install Step 1 Loosen the headlight fairing bolt (9/16" nut - 5/16 allen key) Step 2 Remove the five screws on the back headlight shell with 3/16 allen key. Step 3 Remove the back headlight shell. Step 4 Pull the fairing forward off of the headlight bucket. Pull hard it may be stuck on. Step 5 Unscrew phillips head pinch screw from the nut on the left. Step 6 Remove the clamp ring from bucket. Step 7 Remove lamp and unplug headlight connector. Step 8 Remove black rubber boot. It will not be reused due to lack of room with LED H4. Step 9 Unclip stock H4 bulb. Step 10 Remove stock H4 bulb. Step 11 Install LED H4 base on reflector and clip into place. Step 12 Insert LED bulb into base, align two tips on bulb with slots in base. Push bulb in hard and rotate gently clockwise until stopped. Step 13 Connect driver to bulb and tighten cap clockwise. Step 14 Connect the three prong driver connector to the three prong harness connector. Step 15 Tuck cooling ribbons inside the reflector boot ring. Step 16 Step 17 Route the wires so that looking at the bucket the three prong plug is at 3 o'clock. With the wire going counter clockwise, the driver is at 9 o'clock. The driver connector (shown outside of the bucket) will be placed into the bucket at 6 o'clock, laying front to back, not side to side. See step 18 Step 18 Place driver connector at 6 o'clock, laying front to back as shown. Step 19 Holding the driver in place with thumb, insert lamp while removing your thumb. Rotate lamp until reflector tab is seated into the bucket notch. Step 20 Reinstall the clamp ring onto bucket. Step 21 Reinstall phillips head pinch screw to the nut on the left. Step 22 Push the fairing back on to the headlight bucket. Step 23 Reinstall the back headlight shell. Step 24 Reinstall the five screws on the back headlight shell with 3/16 allen key. Step 25 Reinstall the headlight fairing bolt (9/16" nut - 5/16 allen key) Step 26