Home Page | Contact Us | About Us | Your Account | Basket Contents | Terms & Conditions | CHECKOUT | FREE SHIPPING On orders over $400.00
VRSC V-Rod H911 Install (Two Bulbs) Step 1 Using an 6mm Allen key, remove the two top Allen screws from the headlight bracket Step 2 Pulling screws out of bracket Step 3 Move headlight and bracket away from front end Step 4 Looking at the back of the headlight, rotate counter clockwise & remove H11 bulb. Repeat for H9 bulb Step 5 Unplug connector from H11 bulb, pinch the connector tabs with thumb and forefinger (as shown on left). Repeat for H9 bulb Step 6 Pull H11 bulb from connector. Repeat for H9 bulb Step 7 Connect Headwinds LED H911 bulb. Repeat for second bulb (Different bulb pictured) Step 8 Line up tabs on Headwinds H911 LED bulb with notches on reflector. Repeat for second bulb Step 9 Install and rotate clockwise. Repeat for second bulb Step 10 Push back cables to make room for LED bulbs Step 11 Zip tie cables Step 12 Cut and remove end of zip tie Step 13 With an Allen key tighten screws Step 14 Aim headlight