Intensifier - Wire Schematic


BADLANDS Intensifier IHL-01, IHL-02, IHL-03 HI/LOW Modules

FEATURES:
• Designed to convert a (1) wire incandescent, Halogen or LED light into a dual function or HI/LOW light.
• Install this module to the front or rear turn signal output wires and a protected switched 12+ power source.
• Then the output of our module would feature turn signal and running light functions on (1) wire per side.

PLUG & PLAY INSTALLATION:
• The BLUE wire on the IHL-02 needs 12-volt switched (when the key is on) power from a protected source like a circuit breaker or fuse.
• The BLACK wire should be attached to the frame or ground directly to the (-) side of the battery.

HARD-WIRED INSTALLATION:
• DISCONNECT the battery FIRST!
• We package these modules with butt connectors and quick splices but we recommend using connectors and terminals whenever possible.
• When we say "INPUT" we are referring to the wires attached to our module. For example, on our IHL-02, the VIOLET and BROWN wires
   are considered left and right turn signal INPUTS. These wires should be connected to the OUTPUT of your left and right turn signal switch
   buttons. Once the power, ground and input wires have been connected, it’s time to connect the lighting to the OUTPUT wires on our module.
• Our IHL-02 module provides RUNNING LIGHT and TURN SIGNAL functions for (LEFT = VIOLET) and (RIGHT = BROWN) on any pair of
   incandescent, Halogen or LED light 50-watts or less per side.
• The IHL-02 also works well on single wire spot lights that are under 50-watts a side. Connect the VIOLET and BROWN wire to the HIGH
   side of a HI/LOW switch and the GRAY and YELLOW wires to left and right spot light bulbs. Be sure to test functions when complete.