Load Equalizers are required for turn signals only

Turn signal flashers are designed for use with incandescent (1157) turn signal bulbs
that draw about 2 Amps each, a total of 4 Amps per side. LED bulbs draw only about
.01 Amp. Without the LED load equalizer the turn signals wont blink because the
flasher thinks that one bulb is burnt out.

A load equalizer should be connected to which ever set of turn signals they replace.
If you replace the front set then you need a load equalizer for the front. If you replace
the rear set then you need a load equalizer for the rear. If you replace both front and
rear turn signals you need two load equalizers, one for the front and one for the rear.

• Load Equalizer Wire Schematic: Click here