Terms & Conditions
FREE SHIPPING On orders over $400.00
1-3/8" Halogen to LED Conversion Kit
Click on pictures of underlined words.
Its easy to convert your Headwinds halogen turn signal to an led turn signal since most
of the parts are the same in both units. You'll need to remove the turn signal from where
its mounted and disassemble it. Switch the Halogen threaded spacer inside the housing
for the one below and install the led bulb module. Connect the LED modules to your turn
signal wires and hook up the load equalizer.
NOTE: If you're using this in a Headwinds Spotlight and Turn Signal kit with a stanchion,
you will not need the spacer.
LED BULB MODULE:
8-9110R (Red) Click here
8-9110A (Amber) Click here
3-1017-18LED Click here
ELECTRICAL: Here's a link to the electrical connector section to aid in your wire hook-up.
Not every installation is the same so you'll have to determine what you need. Click here
LOAD EQUALIZER: You will also need a Load Equalizer, Click here
Call us @ (626) 359-8044 with any questions