FREE SHIPPING On orders over $400.00
'06-'11 VRSCD Night Rod 8-9030-H4-X Install
Loosen the headlight fairing bolt (9/16" nut - 5/16 allen key)
Remove the five screws on the back headlight shell with 3/16 allen key.
Remove the back headlight shell.
Pull the fairing forward off of the headlight bucket. Pull hard it may be stuck on.
Unscrew phillips head pinch screw from the nut on the left.
Remove the clamp ring from bucket.
Remove lamp and unplug headlight connector.
Remove black rubber boot. It will not be reused due to lack of room with LED H4.
Unclip stock H4 bulb.
Remove stock H4 bulb.
Install LED H4 base on reflector and clip into place.
Insert LED bulb into base, align two tips on bulb with slots in
base. Push bulb in hard and rotate gently clockwise until stopped.
Connect driver to bulb and tighten cap clockwise.
Connect the three prong driver connector to the three prong harness connector.
Tuck cooling ribbons inside the reflector boot ring.
Route the wires so that looking at the bucket the three prong plug is at 3 o'clock. With the wire going counter clockwise, the driver is at 9 o'clock. The driver connector (shown outside of the bucket) will be placed into the bucket at 6 o'clock, laying front to back, not side to side. See step 18
Place driver connector at 6 o'clock, laying front to back as shown.
Holding the driver in place with thumb, insert lamp while removing your thumb. Rotate lamp until reflector tab is seated into the bucket notch.
Reinstall the clamp ring onto bucket.
Reinstall phillips head pinch screw to the nut on the left.
Push the fairing back on to the headlight bucket.
Reinstall the back headlight shell.
Reinstall the five screws on the back headlight shell with 3/16 allen key.
Reinstall the headlight fairing bolt (9/16" nut - 5/16 allen key)