Home Page | Contact Us | About Us | Your Account | Basket Contents | Terms & Conditions | CHECKOUT | FREE SHIPPING On orders over $400.00
Illuminator Pro III - Wire Schematic PLEASE read these instructions. An improper installation will void the warranty. INSTALLATION: DISCONNECT the battery After cutting, twist the turn signal side of the power wires together. Do not twist the ground wire with the power wires. INPUT refers to the SOLID VIOLET, SOLID BROWN, ORANGE, RED/YELLOW, BLUE and BLACK wires on the module Wires are identified on wire chart below and need a "source" from your bike ORANGE/WHITE wire, connect to a switched and protected source BLACK wire (ground), to the frame or the (-) on the battery VIOLET wire (left side), on the module needs to be connected to your LEFT turn signal switch OUTPUT. BROWN wire (right side) on the module needs to be connected to your RIGHT turn signal switch OUTPUT. VIOLET/WHITE stripe wire, connect to the front left turn signal. This wire will have RUNNING & TURN SIGNAL functions. BROWN/WHITE stripe wire, connect to the front right turn signal. This wire will have RUNNING & TURN SIGNAL functions. GREEN wire, connect to left side indicator light on instrument cluster or speedometer. (not needed if an indicator is not present) WHITE wire, connect to right side indicator light on instrument cluster or speedometer. (not needed if indicator is not available) BLUE wire, SPLICE into the RUNNING light wire going to the rear taillight. This is the RUN in RUN/BRAKE/TURN. RED/YELLOW wire, SPLICE into the BRAKE light wire going to the rear stop light. This is the BRAKE in RUN/BRAKE/TURN. GRAY wire, connect to the rear left turn signal. This wire will have RUN/BRAKE/TURN signal functions. YELLOW wire, connect to the rear right turn signal. Runtime error in mm5/5.00/modules/component/cmp-mmui-pchdft.mvc @ [0000002a:000001f8]: modules/component/cmp-mmui-pchdft.mv: Line 1171: MvDO: No such file or directory