Home Page | Contact Us | About Us | Your Account | Basket Contents | Terms & Conditions | CHECKOUT | FREE SHIPPING On orders over $400.00
1-7041-TERAAAP Install Step 1: Step 2: Bucket should look like this, 2 clips at the top, 1 flat spring at the bottom Step 3: Install speed nut on both clips Step 4: Install screw with spring into speed clips Step 5: Coat three threads, 360°, under the head of socket head cap screw with Loc-Tite (not shown). Insert and tighten screw as shown. Step 6: Install Spring Retainer Clips into square holes of mounting rings Step 7: Install coil spring over retainer clip Step 8: push the eye of the spring retainer clip over the screw Step 9: Pull up flat spring over the screw to keep retainer clip from coming off screw Step 10: place black ring losely on mounting ring. depress mounting ring and alight small notch on the black ring with the bottom of the headlight (as shown). push back ring in to mounting ring and then release the mounting ring. Step 11: continue to press black ring into mounting ring. Step 12: using a screwdriver, push black ring into mounting ring around it's periphery. Step 13: Step 14: Strip 1/4" insulation off the wire and feed in to butt splice cap. Step 15: holding the cap, screw butt splice barrel on to the cap. Step 16: repeat for high beam (white), low beam (yellow) and ground (black). connect your stock wires to butt splices. plug lamp in, turn on the light and test high and low beam to assure connections are correct Step 17: place lamp into mounting ring Step 18: place retaining ring over lamp. Step 19: push the first side of retaining ring and lamp into bucket. Step 20: holding the first side, push the second side in. Step 21: holding first and second side, push in the top. Step 22: you might have to use a little impact with the heel of your hand. Step 23: make sure the bottom of the lamp is aligned with the bottom of the bucket. Step 24: That's It!