FREE SHIPPING On orders over $400.00
Load Equalizers are required for turn signals only
Turn signal flashers are designed for use with incandescent (1157) turn signal bulbs
that draw about 2 Amps each, a total of 4 Amps per side. LED bulbs draw only about
.01 Amp. Without the LED load equalizer the turn signals wont blink because the
flasher thinks that one bulb is burnt out.
A load equalizer should be connected to which ever set of turn signals they replace.
If you replace the front set then you need a load equalizer for the front. If you replace
the rear set then you need a load equalizer for the rear. If you replace both front and
rear turn signals you need two load equalizers, one for the front and one for the rear.
Load Equalizer Wire Schematic: Click here