Home Page | Contact Us | About Us | Your Account | Basket Contents | Terms & Conditions | CHECKOUT | FREE SHIPPING On orders over $400.00
LED H4-X Bulb Install - XLH ('03-on), FXD, FXDWG, FXST, FXWG, FXSTS (to '94) Step 1: Headlight Removal (as shown) Not Required. Unscrew phillips head pinch screw from the nut on the left. Step 2: Remove the clamp ring from bucket. Step 3: Remove lamp and unplug headlight connector. Step 4: Remove black rubber boot. Do not put it back on due to lack of room with LED H4. Step 5: Unclip stock H4 bulb. Step 6: Remove stock H4 bulb. Step 7: Install LED H4 base on reflector and clip into place. Step 8: Insert LED bulb into base, align two tips on bulb with slots in base. Push bulb in hard and rotate gently clockwise until stopped. Step 9: Connect driver to bulb and tighten cap clockwise. Step 10: Connect the three prong driver connector to the three prong harness connector. Step 11: Tuck cooling ribbons inside the reflector boot ring. Step 12: Step 13: Route the wires so that looking at the bucket the three prong plug is at 3 o'clock. With the wire going counter clockwise, the driver is at 9 o'clock. The driver connector (shown outside of the bucket) will be placed into the bucket at 6 o'clock, laying front to back, not side to side. See step 18 Step 14: Place driver connector at 6 o'clock, laying front to back as shown. Step 15: Holding the driver in place with thumb, insert lamp while removing your thumb. Rotate lamp until reflector tab is seated into the bucket notch. Step 16: Reinstall the clamp ring onto bucket. Step 17: Reinstall phillips head pinch screw to the nut on the left. Step 18: Aim The Headlight Click here